User manual

Engineering
3.3 STEP 7 in the TIA-Portal
SITOP UPS1600 / UPS1100
42 Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
3.3.2
Integrating UPS1600 into a project
To be able to use UPS1600, it must be assigned to an IO controller as an IO device. Further,
UPS1600 can be equipped in the project with one or several UPS1100 battery modules.
The main views for the configuration of the UPS1600 are the network view and the device
view.
Note
Additional information
on the network view and device view as well as the topology view is
provided in the STEP 7 manual in the TIA Portal.
Preconditions
● The hardware support package of UPS1600 has been correctly installed.
● STEP 7 in the TIA-Portal has been opened, and a project has been created with an IO
controller .
Inserting UPS1600 from the hardware catalog
1. Open the network view.
2. Open the "Hardware catalog" task card.
3. In the "Catalog" palette navigate to the UPS1600 under Power supplies\SITOP
UPS\UPS1600.
4. Select the required UPS1600 using a mouse click.
In the "Information" area you can see information about the selected UPS1600.
5. Drag the UPS1600 and drop it into the Network view.
You have now placed the UPS1600 in the Network view. The rectangle displayed
symbolizes the UPS1600.