Datasheet

Supplied active power typical 960W
Product feature parallel switching of outputs Yes; Parallel circuit Output 1 with 2 or Output 3 with 4 can be
selected via DIP switch
Parallel switching for enhanced performance No
Efficiency
Efficiency at Vout rated, Iout rated, approx. 93%
Power loss at Vout rated, Iout rated, approx. 72W
Power loss [W] during no-load operation maximum 20W
Closed-loop control
Dynamic mains compensation (Vin rated ±15 %),
max.
0.1%
Dynamic load smoothing (Iout: 50/100/50 %), Uout ±
typ.
0.4%
Setting time maximum 10ms
Protection and monitoring
Output overvoltage protection < 35 V
Property of the output Short-circuit proof Yes
Short-circuit protection electronic overload cut-off; optionally constant current operation
can be selected for Output 4 via DIP switches
adjustable response value current of current-
dependent overload trip
0.5...10A
type of threshold value setting via potentiometer
characteristics of electronic overload switch-off Ia >1.0…<1.5 x Ia threshold permissible for 5 s; Ia limit (= 1.5 x Ia
threshold) permissible for 200 ms
characteristics of constant current operation Ia limit (= 1.5 x Ia threshold) permissible for 5 s, afterwards Ia
threshold continuous
Reset Via sensor per output
Remote reset Non-electrically isolated 24 V input (signal level "high" at > 15 V)
Overcurrent overload capability in normal operation Total system overloadable 150% Ia rated to 5 s/min
Overload/short-circuit indicator 3-color LED for operating state device; 3-color LED per output for
operating state output
Interface
Specification interface Ethernet/PROFINET
Safety
Primary/secondary isolation Yes
Galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN
50178
Protection class Class I
Leakage current
● maximum
3.5mA
CE mark Yes
UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259;
cCSAus (CSA C22.2 No. 60950-1, UL 60950-1)
6EP3437-8MB00-2CY0 Subject to change without notice
Page 3/
5
07/30/2018 © Copyright Siemens