Datasheet

● at rated input voltage 220 V
0.7A
Switch-on current limiting (+25 °C), max. 35A
I²t, max. 1A²·s
Built-in incoming fuse T 3.15 A (not accessible)
Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: 6-10 A characteristic C
Output
Output Controlled, isolated DC voltage
Rated voltage Vout DC 24V
Output voltage 3-52 V DC
Total tolerance, static ± 1%
Static mains compensation, approx. 0.1%
Static load balancing, approx. 1%
Sense line connection max. voltage control per line 0.5V
Residual ripple peak-peak, max. 50mV
Spikes peak-peak, max. (bandwidth: 20 MHz) 100mV
Adjustment range 0...52V
Product function Output voltage adjustable Yes
Output voltage setting via potentiometer (setting range 3 to 52 V) or analog control
voltage signal 0 to 2.5 V (setting range 0 to 52 V)
Status display Two-color LED: green for 24 V o.k., red for overload
Signaling DC OK via relay contact, current monitor signal (0 to 2.5 V
correspond to 0 to 10 A)
On/off behavior No overshoot of Vout (soft start)
Startup delay, max. 0.5s
Voltage rise, typ. 20ms
Rated current value Iout rated 10A
Current range 0...10A
● Note
Output power max. 120 W
Supplied active power typical 120W
Constant overload current
● on short-circuiting during the start-up typical
12A
● at short-circuit during operation typical
12A
Parallel switching for enhanced performance Yes
Numbers of parallel switchable units for enhanced
performance
2
Efficiency
Efficiency at Vout rated, Iout rated, approx. 88%
Power loss at Vout rated, Iout rated, approx. 16W
Power loss [W] during no-load operation maximum 3W
Closed-loop control
Dynamic mains compensation (Vin rated ±15 %),
max.
0.3%
6EP3343-0SA00-0AY0 Subject to change without notice
Page 2/
4
06/20/2019 © Copyright Siemens