User Manual

LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
42 Manual, 04/2011, A5E03556174-01
Removal
To remove LOGO!:
....... if you have installed only one LOGO! Base Module:
1. Insert a screwdriver into the eyelet at the bottom of the slide interlock and move the latch
downward.
2. Swing the LOGO! Base Module off the DIN rail.

$




$%



/2*2%$
/2*2%$


%


....... if you have connected at least one expansion module to the LOGO! Base Module:
1. Using a screwdriver, push the integrated slide interlock to the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the slide interlock and lever it
downward.
4. Swing the expansion module off the profile rail.