Install Instructions

ManualsBrandsSiemens ManualsControl ValvesFlowrite 1/2" to 2" Normal Duty Bronze Packing Replacement Kit

Document No. 129-215

Installation Instructions

September 29, 2009

Page 8 of 9 Siemens Industry, Inc.

Installation, Continued

4. Lower the valve stem.

5. Use a 5 mm hex wrench to loosen the lock

screw and the yoke nuts.

6. Remove the actuator from the valve, being

careful not to damage the valve stem.

7. Return to the instructions for Removing the

packing cartridge.

Assembling the actuator to the valve

1. Place the actuator onto the valve bonnet.

2. Raise the valve stem to meet the stem retainer.

3. Hold the stem retainer in place as you tighten it

around the valve stem. See Figure 6.

4. Hold the actuator in place as you fasten the

yoke nuts and lock screw with a 5 mm hex

wrench.

EA0481R1

Figure 19. Fastening the SXQ Actuator to the Valve.

Electro-Mechanical Actuators

Tools

 5/32-inch hex wrench

 Medium flat-blade screwdriver

CAUTION:

Do not damage or scratch the polished

surface of the valve stem.

Removing the actuator

1. Turn off the power to the actuator.

2. Use the screwdriver to pry off the linkage cover

from the linkage body assembly.

3. Remove the stem clip holding the valve stem.

See Figure 20.

EA0267R1

STEM

CLIP

5/32" HEX

Figure 20. Electro-Mechanical Actuator.

4. Lower the valve stem.

5. Use a 5/32-inch hex wrench to loosen the set

screws in the bonnet bracket. See Figure 20.

6. Remove the actuator from the valve bonnet

being careful not to damage the valve stem.

7. Remove the e-ring from the valve stem.

8. Return to the instructions for Removing the

packing cartridge.

Assembling the actuator to the valve

1. Fasten the e-ring to the valve stem.

2. Raise the valve stem to the desired height.

3. Place the actuator over the valve bonnet.

4. Use a 5/32-inch hex wrench to tighten the set

screws in the bonnet bracket.

5. Insert the stem clip through the bottom slot in

the cage. See Figure 21.

Figure 21. Location of the Stem Clip and E-ring.

6. Fasten the stem clip in the groove of the valve

stem beneath the e-ring.

7. Place the linkage cover onto the linkage body

assembly.

The installation is now complete.