Specifications

XMU+ Installation and Maintenance Guide rev.07 89
Understanding XMU+ Remote Telephone Access
Remote Telephone Access Commands
Note: nnn = partition, message, or access code number
x = card number, y = line number, z = language number
* = only available with partitioning enabled
** = only available with partitioning disabled
+ = Message number ‘0’ is a temporary message (Standby Message), which can be
recorded and played without affecting any other messages. When the user decides that
the temporary message is recorded properly, they can replace any message in the XMU+ with
the temporary message. When the user disconnects, the temporary message is automatically
erased.
To do this...
Use this Interactive
Command...
Or this Direct
Command...
Record Message 7#, then nnn# 7nnn#
Record Standby Message+ 7#, then 0# 70#
Play Message 8#, then nnn# 8nnn#
Replace Message 9#, then nnn# 9nnn#
Delete Message 39# then nnn# 39nnn#
Delete Messages in a List Node 51# then nnn# 51nnn#
Change System Access code 1#, then 0#
(administrators only)
10#
(administrators only)
Change Partition Access code
using System Access code*
1#, then nnn#
(administrators only)
1nnn#
(administrators only)
Change Partition Access code* 1# 1#
Change Message Access code** 1#, then nnn# 1nnn#
Obtain Line Counts 2#, then xy 2xy#
Switch Partition* - 0nnn#
Obtain line counts for all lines on
a card
2#, then x, then 0 2x0#
Clear all line counts - 299#
Terminate Remote Access and
Restart
- 00#
Disconnect 0# 0#
Change Remote Access Language - 4z#
Change Partitions* - 0nnn#
Turns message on 31#, then nnn# 31nnn#
Turn message off 30#, then nnn# 30nnn#
Override Enabled - 591#
Override Disabled - 590#