Specifications

XMU+ Installation and Maintenance Guide rev.07 43
Preparing to Cable the XMU+
Matching XMU
+
Cables and Connectors
Use the following table to match Control card and line card connectors to the
appropriate cables and mating connectors. While Control card connectors are the
same on every XMU+ unit, the number and type of line cards can vary. See Line Card
Checklist on page 14 for a list of the line cards pre-installed in the XMU+.
Some cables are shipped with the XMU+, but others may need to be purchased
separately. See “Cable Checklist” in Chapter 1 of the XMU+ Installation Handbook for
a list of cables shipped with this XMU+.
XMU+
Card...
Connector
on card...
Used
to...
Requires connector
and cable...
Control
Card
MODEM -
RJ-11
connector
Communicate with
XMUCOM+.
RJ-11 Mating Connector
(telephone jack) and
telephone cable.
REMOTE -
RJ-11
connector
Program messages from
a remote location using
a touch tone telephone.
RJ-11 Mating Connector
(telephone jack) and
telephone cable.
ALARM -
Alarm
Connector
Connect alarm circuitry. Alarm Mating Connector
and ribbon cable.
SERIAL-1 Perform future
applications.
SERIAL-2 Perform future
applications.
NETWORK -
RJ-45
Set up connections to
XMUCOM+ software via
an Ethernet network.
RJ-45 to RJ-45 (6ft.)
Category 5 UTP network
connector and cable for
LAN connection.
Low
Impedance
Line Card
J5 - RJ-21
Female
Connector
Perform ACD/UCD
applications only.
Amphenol RJ-21
50-pin male connector
and cable.
MWR Line
Card
J5 - RJ-21
Female
Connector
Perform MWR
applications only.
Amphenol RJ-21
50-pin male connector
and cable.
MWR
Mini Weather
Radio
MOH
Music On Hold
ACD
Automatic Call
Distribution
CAT5
Standard
Category 5