Specifications

124 Chapter 10
Troubleshooting XMU+ Installation
The following is a list of the line status indicators:
 ‘-’ - line not installed
 ‘N’ - offline
 ‘E’ - configuration error exists
 ‘Y’ - line idle
 ‘M’ - call transfer queue MOH message
 ‘C’ - line connected
 ‘R’ - ringing on line
 ‘H’ - hold messages being played
 ‘b’ or ‘B’ - call transfer detecting a busy cadence
 ‘A’ call transfer detecting line has been answered
 ‘r’ or ‘R’ - call transfer detecting ring-back cadence
 ‘0 -9’ , ‘#’ , ‘*’ - DTMF digits generated
 ‘ , ' - 1/2 second pause
 ‘ ! ' - hookflash
 ‘d’ or ‘D’ - call progress monitoring
To perform a line check
The Line Check feature checks the lines to ensure a telephone line is connected to the
channel. It is only used for lines that are configured to Ring Start mode. See To check
operating modes on page 123 to confirm that the line is in Ring Start mode.
1. Press Enter to access the Main Menu.
2. Press the Right Arrow to reach System on the Main
Menu, and press Enter.
3. Press the Right Arrow to reach Diagnostics, and press
Enter.
4. Press the Right Arrow to reach Line Check, and press
Enter.
5. Press the Right Arrow to reach the desired card and
line to be tested, and press Enter.
Each line will display Pass or Fail.
6. Repeat Step 5 until all the desired cards and lines are
checked:
 If all line cards pass the line check, proceed to the
next troubleshooting task - To p er for m an integ r it y
check.
 If any line cards fail the line check, ensure a starting node is assigned. See
Test ing XMU+ Line Connections on page 100.



