Specifications

100 Chapter 8
Testing XMU+ Installation
Testing XMU
+
Line Connections
Each telephone line connected to the XMU+ should be tested to ensure proper
connection to the PBX. To ensure that the lines are actually ringing, and that the
XMU+ is answering correctly, you must:
 Ensure that a message has been recorded. See To record a message on page 83
(via Front Panel) or To record a message remotely on page 91(via Remote Access).
 Assign the message to a line. See Test ing XMU+ Line Connect ions on page 100.
 Set the XMU+ mode of operation. See To set line card operating modes on page
102.
 Test the telephone line to ensure the message plays. See To tes t lin es on page 103.
Note: Although all tasks in this section can be completed using Front Panel and
XMUCOM+, only the steps using the Front Panel are shown. See Understanding the
XMU+ Front Panel on page 81 for more information.
To assign messages to a line (from the Front Panel)
In order to configure the XMU+ to play messages, each message must first be
configured to play on the appropriate line. The number of lines on the XMU+ is
determined by the number of line cards installed. See Line Card Checklist on page 14
to determine the number of line cards installed.
When you assign a message to a line, it becomes that line’s starting node. By default,
the XMU+ assigns message 1 to line 1’s starting node, message 2 to line 2’s starting
node, and so on.
1. Press Enter to access the Main Menu.
2. Press the Right Arrow until you reach Card on the Main Menu, and press
Enter.
3. Press the Right Arrow until you reach the appropriate line card number, and
press Enter.
4. Press Enter to select Select Line.
5. Press the Right Arrow until you reach the line to which you want to assign a
message, and press Enter. You can choose:
 One of the 8 lines on the line card (individually). Press Enter again to
accept.
 All lines (1 to 8). When ALL is selected, a warning message appears. Press
Enter again to accept.