Specifications

98 Chapter 8
Testing XMU+ Installation
Assigning and Testing IP addresses
1. Press Enter on the XMU+ Front Panel to access the Main
Menu.
2. Press the Right Arrow to reach System on the Main
Menu, and press Enter.
3. Press Enter to access Communications.
4. Press Enter to select Ethernet.
5. Press Enter to select IP Address.
The XMU+ displays the default IP address.
6. Press Enter to make the first three digits of the address
flash.
7. Change the first three digits of the address using the
Right Arrow (to increase the number) and Left Arrow
(to decrease the number), and then press Enter. The next
three digits of the address will begin to flash.
8. Repeat Step 7 until the appropriate IP address has been
entered, and press Enter.
9. Press Exit until the menu returns to the main display.
10. If required, assign an IP Netmask and IP Gateway to the
XMU+ by:
 Repeating Steps 1 to 4, above.
 At Step 5, pressing the Right Arrow to reach IP
Netmask or IP Gateway, and then pressing Enter.
 Continuing with Steps 6 to 9 to change the default IP
Netmask or IP Gateway.
Note: Normally, the default IP Netmask and IP Gateway are used
for communication with XMU+. If these numbers are changed in the procedure
above, ensure that the new numbers are recorded in Communication Specifications
on page 25 of The XMU+ Delivery Checklist .





TIP...
To change only a
select group of three
digits:
 Press Enter until
the appropriate
group of three
digits is flashing.
 Change the
digits.
 Press Exit twice to
return to the
Ethernet menu.