Installation Instructions

Installation Instructions
Document No. 540-148
August 15, 2012
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models
as design improvements are introduced. TALON is a registered trademark of Siemens Industry, Inc. Other product or company names
mentioned herein may be the trademarks of their respective owners. © 2012 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
[phone]
Your feedback is important to us. If you have
comments about this document, please send them
to [e-mail]
Document No. 540-148
Printed in the USA
Page 4 of 4
Review Table 3 to verify that you have the appropriate
mounting hardware.
For retrofit installations, normally follow the method used by
the pre-existing device. You may need to replace existing
mounting hardware. Always mount the sensor vertically.
Table 3. Mounting Accessories.
P/N Description Used For Reference
182-621E Gym Guard Kit, satin chrome gyms and similar environments requiring a guard.
(Incompatible with adapter bases and the extender ring.)
155-222P25
(TB 193)
182-683 Metal (and Wood) Stud
Mounting Bracket (pkg. 5)
Single-sensor rough-in installations. Kit includes locator. 129-057
182-685 Spring Clips: Finished Drywall
Mounting Kit
(10 pack)
Drywall mounting. 129-073
192-506 Electrical Box Adapter Plate
Assembly Kit (pkg. 5)
Electrical boxes mounted flush with the wall and for gyms
and similar environments requiring a guard. (Also see
Part Number
544-782.)
Figure 5
192-860 Finish Plate Kit 1 Gang 1
Sensor; stainless steel
Single-sensor, low-cost mounting. Plate is 3.7 × 5.1
inches
(9.5 × 12.9 cm).
155-252P25
(TB 238)
536-666 Mounting Strap Standard light switch plate (field-supplied) to mount
sensor on 2 × 4 electrical box.
540-040; 540-237
544-782B Single Adapter Base Mounting
Kit, white
2 × 4 boxes, all single sensor installations on walls with
oversized holes, paint lines, etc., that need to be covered,
and on exterior brick/cement-type walls. Kit includes
Electrical Box Adapter Plate Assembly (Part Number
192-495. Adapter base is 3-1/2 × 5 inches
(8.8 × 12.7 cm).
Figure 5
544-783B Double Adapter Base
Mounting Kit, white
4 × 6 boxes and all double sensor installations on walls
with oversized holes, paint lines, etc., that need to be
covered, and on exterior brick/cement-type walls. Kit
includes two mounting plates (Part Number 192-720).
Adapter base is 5 × 7 inches
(12.7 × 18 cm).
Figure 5
544-784 Non-conduit Rough-in Kit,
Double
Double-sensor non-conduit rough-in installations. Kit
includes locator.
540-784
544-785B Extender Ring Kit Exterior brick or cement-type walls; fits to back of sensor
base plate.
—
544-800 Universal Adapter Kit Retrofitting a previous horizontal installation to a vertical
one, or when the screw spacing does not fit the electrical
box adapter plate. Kit includes multi-slotted adapter plate.
Figure 5
981-344 Electrical Box Cover Plate Kit 2 × 4 box rough-ins. Kit includes locator and connector. —