User Manual

IO-Link
10.1 Configuring the IO-Link
SIRIUS ACT 3SU1 pushbuttons and signaling devices
208 System Manual, 02/2015, A5E03457306020A/RS-AB/002
10.1.3
Configuring with the S7-PCT Stand Alone Port Configuration Tool
10.1.3.1
Application
Configuration is always done with the S7-PCT port configuration tool whenever no
SIMATIC CPU is available.
10.1.3.2
Basic procedure and prerequisites
Basic procedure when configuring IO-Link master and IO-Link devices with the S7-PCT Port
Configuration Tool (stand-alone)
1. You configure the connected IO-Link devices with the S7-PCT Port Configuration Tool.
Requirements
● The S7-PCT Port Configuration Tool is installed on the PG/PC.
You can either install
S7-PCT together with STEP 7 V5.4 SP5 or higher or STEP 7 TIA
Portal V12.0 or higher, or you can download it from the Internet
(http://support.automation.siemens.com/WW/view/en/37936752).
● IO-Link IODD files (IO Device Description) are installed in the S7-PCT hardware catalog.
All current IODD files of the SIRIUS devices are available on the Internet
(https://support.industry.siemens.com/cs/#products?search=IODD&o=DefaultRankingDes
c&lc=en-WW).
IODD files for V1.0 and V1.1 are available for the combination of an IO-Link master and
an IO-Link device according to the IO-Link communication specification V1.1. You may
need IODD files according to the communication specification V1.0 when replacing
devices in existing installations.
Note
Configuring with S7-PCT stand-alone is not possible for the CPU versions of the ET 200.