Install Instructions

Installation Instructions
Document No. 129-144
September 25, 2009
Retrostat Cover Kits
Item Number 129-144, Rev. 300 Page 1 of 2
Product Description
The Retrostat Cover kits provide an adaptable cover
for use with the TH 19X thermostat.
Contents
Part
Quantity
Retrostat Cover 1
Bezel 1
Dial Plates 6
Thumb Wheel Hole Cover 2
Product Numbers
Retrostat Kit
Type
192-868 Desert Beige Cover
192-868W White Cover
Prerequisites
• Review all of these instructions before you
begin installation.
• Check job drawings for any site-specific
information.
Expected Installation Time
5 minutes
Required Tools
• Needle nose pliers
Installation Conventions
WARNING
Personal injury/loss of life may
occur if a procedure is not
performed as specified.
CAUTION
Equipment damage, or loss of
data may occur if the user
does not follow procedure as
specified.
Installation
See Figures 1 and 2.
1. Determine which dial plate is needed and place
it in the recessed area on the front of the cover.
CAUTION:
Always make certain you select the
proper dial plate before installing the
bezel. The bezel is difficult to remove
once it is in place on the retrostat
cover.
2. Place the bezel over the dial plate and snap it
into place.
3. Use the thumb wheel hole covers to hide any
unused openings or to conceal any thumb
wheels.
4. For day/night thermostats use a needle nose
pliers to carefully remove the plastic cover from
the day/night selector handle slot. Discard this
cover.
5. Install the cover assembly to the device on the
wall.
The installation is complete.