Data Sheet for Product

Technical Bulletin Powers Controls TH 192 Adapter Kits
Document Number 155-231P25
Rev. 2, December, 2001
Page 10 Siemens Industry, Inc.
Required Parts for Installation
A. Terminal Plate (11-hole)
B. (2) Terminal Fitting
C. (2) Holder
D. (2) Gasket
E. (1) No. 6-32 × 9/16-inch Flat-head Screw and
(1) No. 8-32 × 7/16-inch Long Binder Head Screw
F. (4) Tube Retainer
G. (2) 5/32-inch (4 mm) Plastic Tube (Soft) and Coil
H. Multi-slotted Plate
J. (2) No. - 6-32 × 1-1/2 inch Pan Head Screw
*K. Adapter Frame
*L. Adapter Base
*P. (2) Plug-in Adapter
*Items not shown. See Figure 2 for proper installation.
Required Parts for Installation
A. Terminal Plate (5-hole)
B. (2) Terminal Fitting
C. (2) Holder
D. (2) Gasket
E. (2) No. 6-32 × 5/8-inch Long Binder Head Screw
F. (4) Tube Retainer
G. (2) 5/32-inch (4 mm) Plastic Tube (Soft) and Coil
H. Multi-slotted Plate
J. (2) No. 6-32 × 1-inch Long Binder Head Screw
*L. Adapter Base
*P. (2) Plug-in Adapter
*Items not shown. See Figure 2 for proper installation.
Figure 20. Johnson H & T 4000, 5000 Flush Box.
Required Parts for Installation
F. (2) Tube Retainer
G. (2) 5/32-inch (4 mm) Plastic Tube (Polyethylene- Hard) and Coil
H. Multi-slotted Plate
J. (2) No.6-32 × 1-1/2 inch Pan Head Screw
*L. Adapter Base
N. (2) Tubing Adapter (5/32-inch × 5/32-inch or 1/4-inch × 5/32-inch)
*P. (2) Plug-in Adapter
*Items not shown. See Figure 2 for proper installation.
Figure 19. Johnson T400, 401, 403, 432, 460, 465,
H101, 102, 103, 105 Flush Fitting.
Johnson Bishop
Swan (Old Round Head) and Babcock
E. (2) No. 8-32 × 7/16-inch E- (2) No.10-24 × 3/4-inch
Binder Head Screw Head Screw
NOTE: If terminal head is too close to the wall surface, loop
around plastic tubing as shown on Powers Controls "D"
Thermostat Installation. See Figure 6.
Figure 21. Swan, Bishop & Babcock Flush Fitting. Figure 22. Robertshaw T18, T19, 32 Flush Box.