User Manual

Siemens A6V10733768_en--_b

2020-04-29

CAUTION

The devices are not protected against accidental connection to AC 230 V.

● Use the correct cables for the KNX PL-Link bus.

● Do not interchange the wires of the KNX PL-Link cable.

● Observe all local installation regulations.

Commissioning

Prerequisites

Before commissioning the device, make sure an application is downloaded into the

connected controller, from where the functions are downloaded in the device.

Download the application using SSA-DNT (Pack & Go) or ABT.

For this purpose (or for service), connect ABT to the controller via USB or Ethernet.

Automatic commissioning

When connected to the KNX PL-Link bus, the device automatically communicates with the

connected controller. The following routine is executed.

Step With display Description

1 Build number and version of the device are displayed.

2 The individual address (IA) is downloaded into the

device via KNX PL-Link.

This step is skipped if the device is already configured.

Note: The configuration file can be downloaded any

time; as a result, these characters are displayed every

time the controller initializes download.

3 After startup, the device displays a normal operation

page.

(The operation page displayed on the left side is a

sample view; the view depends on the application

selected on the controller.)

3b When the configuration is faulty, "Unconfigured" is

displayed along with the temperature measured by the

local temperature sensor.

In this case, manual commissioning must be performed

(see below).