User's Manual

Réf. : DIT/NYL/26.0125.02/SA/SA Ed/Rév :0001/00 Trad.: --
Mémo : 648291 Date : 25/10/2002
STS TRAIN RADIO - USER MANUAL - FCC TEST CONFIGURATION
- 13 / 16-
Siemens Transportation Systems exclusive property
5. CONFIGURATION OF THE MENU (VERSION 3.1)
please choose: 2
Please select the Tx mode :
for normal mode : enter 0
for permanent Tx mode (4.125ms/4.125ms) : enter 1
for permanent Tx mode (5s/5s) : enter 2
Mode = ?
Mode = ? 0
This mode is not availabl
e
running …
please choose: 3
th
e
Tx mode is permanent Tx mode (4.125ms/4.125ms)
Frequency F = channel 0
The power level is P0
The active RF output is RFA2
running …
please choose: 0
loading ...
loading OK
running ...
please choose: 1
WARNING : the current code will be erase
d
Do you want to proceed ? 1=YES ; 0=NO
0
The code was not erase
d
running ...
*
******************************************
*
******************************************
*
RF Configuration Menu v3.1 *
*
******************************************
*
******************************************
0 : Load FPGA cod
e
1 : Download new FPGA cod
e
2 : Program th
e
Tx mode
3 : Check Mode / Parameters
please choose:
Please select the active RF output :
for RFA1 output : enter 1
for RFA2 output : enter 0
Selection = ?
Selection = ? 0
You have selected the RFA2 output
Please enter the channel number you want to select (0 to 8)
Mode = ? 1
You have selected the permanent Tx mode (4.125ms/4.125ms)
1
writing memor
y
erasing FPGA code ...
F9FAFBFCFDFEFF
FPGA code erase
d
waiting for the programming file (*.HEX)
Selection = ?
You have selected the RFA1 output
Mode = ? 2
You have selected the permanent Tx mode (5s/5s)
F = ? 0
You have selected F = channel 0
Please select the power level :
for P0 power level : enter 0
for P1 power level : enter 1
for P2 power level : enter 2
Selection = ?
Selection = ? 0
You have selected the P0 power mod
e
running …
F = ? 8
You have selected F = channel 8
……
…………
Selection = ? 1
You have selected the P1 power mode
running …
Selection = ? 2
You have selected the P2 power mod
e
running …
Figure 6 : Configuration of the menu
Notes :
 When powered on, the MRAD begins to emit with the previous parameters. If no parameter
was ever entered, there is a warning : “the Tx mode is unknown” and all parameters (Tx mode,
RF output, frequency, power level) must be defined.
 During the RF configuration, the MRAD continues to emit.
 Each new parameter is applied immediately after input.