Product manual

Product Manual U42006-J-Z795-1-7600

Working in emulation sessions Status line display

LINE

The

LINE light goes on when the connection is established to the computer.

MCR

If the host requested an authorization card, the

MCR light goes on; once the infor-

mation on the authorization card is transferred to the computer, the display dis-

appears.

MCR ERROR

This is displayed if an error relating to the card reader connected occurs.

NUM

The

NUM light goes on if the cursor is moved in a numerical field; as soon as the

cursor leaves the field again the display goes out again.

Number (e.g. 2/40)

The two numbers specify the position of the cursor (line/column). If you prefer

a linear specification (position in the data stream, calculated from the top of the

screen) you can configure this setting (see help „Terminal setup“, „Displaying

the cursor position“).

POLL

POLL flashes if no signal is received by the host but the line is nonetheless

available.

PR1, PR2 ... PR7

PDEV1, PDEV3

If a print job is started by a user or the host program, this status display lights

up until the print process terminates or you press the (Reset) key. The dis-

play lights up if there are problems with the connection to the printer or with the

printer itself; if an error occurs with the print output, an additional flashing error

code (

F0, F1...) is displayed.

RECV

The

RECV light goes on if data transmission has begun and goes off when the

data has been transmitted or you press the (Reset) key after a transmis-

sion error. The

RECV display flashes if data transmission was canceled because

of a transmission error.