Product manual

Product Manual U42006-J-Z795-1-7600
Working in emulation sessions Status line display
7.8 Status line display
The status line or device status line that is displayed at the bottom of the screen
is described in detail in the Operating Manual for the 9750-type data display ter-
minal. The following description is intended to explain the messages displayed
in this line.
BEL
BEL is called or deleted by control characters from the application program. You
can reset the display by pressing .
DIA
The
DIA light goes on when you switch to dialog mode and goes off when you
exit this mode. Dialog mode starts when you press the data transmission key
(RECV key) and ends when the message is received from the BS2000 host.
ERR
ERR
flashes if you made an error in input; when you correct the input or press
the key, the display goes out once again.
F0, F1, F2, F4, F8
These displays indicate errors relating to hardcopies on the local printer.
H
H indicates that the host has changed the P key mapping.
HPT
The
HPT light goes on when you press the HPT key.
INS
The
INS light goes on if you press the Insert Character; it goes off if you press
the key or if data transmission is initiated.
KEYB
This display is lit up when the keyboard is connected and operable. If the key-
board is not connected or is defective,
KEYB flashes.
RS
RS
RS