Product manual

Product Manual U42006-J-Z795-1-7600
Preparing/configuring the product
4 Hardware and software
requirements
This section describes the hardware and software components required to ope-
rate the MT9750 emulation program .
4.1 PC
The requirements for using MT9750 depend primarily on the operating system
used. The minimum requirements for use are an 80486SX/DX or Pentium® pro-
cessor and 8 Mbytes of main memory, these values increase considerably for
use under Windows NT. In addition, the memory requirements of other Win-
dows applications which will be used must be taken into consideration. It is the-
refore essential when planning hardware that you take account of the operating
system specifications in particular.
The amount of free memory required on your hard disk depends on the com-
ponents to be installed, but approximately 4 Mbytes should generally be suf-
ficient. A CD-ROM drive is required if you are installing the full product or the
admin program (no client installation). The online documentation supplied is
also on CD-ROM and is read from there as required.
A VGA
®
monitor is required for MT9750. We recommend a resolution of at least
800x600 pixels and that it be configured with 32k colors.
MT9750 supports country-specific standard PC keyboards, as well as trimodal
keyboards.
You need Microsoft Windows 95 or MS Windows NT to run MT9750 V5.0. It
cannot be installed under 16-bit operating systems.
In addition, a suitable communication board (also called an interface board in
the following chapters) must be installed and configured in your PC for data
communication in the LAN. If you have questions on this subject, contact the
manufacturer or vendor of the communication board.