Specifications

System configuration Docking Unit Setup
Configuring the docking unit - Docking Unit
Setup
The Docking Unit Setup submenu only appears if the notebook is attached to a
docking unit.
You can specify the following in Docking Unit Setup:
– Hard disk drive C: (in the field marked Hard Disk Boot)
– Floppy disk drive A: (in the field marked Diskette Boot)
– The docking unit's display controller (in the field marked Primary Display)
– The display controller used by the notebook (in the field marked Internal VGA)
– The type of pointing device (in the field marked Pointing Device)
F3D31 Docking Unit Setup 01.09.95
---------------------------------------------------------------------------
External Diskette: 1.2MB 5.25Inch
Cyl Hd Sec Mbyte
External Hard Disk: Auto 985 13 32 200
Hard Disk Boot: Internal
Diskette Boot: Enable
Primary Display: VGA/EGA
Internal VGA: Automatic
Pointing Device: PS/2 Type
SCSI Drive: Disable
I/O: 340h
IRQ: 11
---------------------------------------------------------------------------
Esc F3 F10 ↑↓ ←/→
Main Menu Set Default Save Field Value
The Docking Unit Setup submenu
External Diskette
In this field you specify the type of floppy disk drive (if any) installed in the docking
unit.
Options: 360 KB, 720 KB, 1.2 MB, 1.44 MB, 2.88, and None (default: None)
Default entry: None
External Hard Disk
This field shows the type of hard disk installed in the docking unit.
68 A26391-K64-Z100-2-7619