Specifications

System settings - System Setup System configuration
Internal Hard Disk
External Hard Disk
These two fields show the types of hard disk installed in the notebook (internal) and
in the docking unit (external). The external hard disk type only appears if the
notebook is attached to a docking station in which a hard disk is installed.
Base Memory
This field shows the amount of base memory available below 1 Mbyte.
Extended Memory
The Extended Memory field shows the amount of available memory above 1 Mbyte.
COM Port
This field is used to specify the port address and the interrupt request used by the
serial port.
COM1 The serial port uses the address 3F8h and IRQ4 (default).
COM2 The serial port uses the address 2F8h and IRQ3.
Disable The serial port is disabled.
IR Port
This field defines the address and the interrupt for the serial interface.
COM1 The infrared interface is set to address 3F8h and IRQ4.
COM2 The infrared interface is set to address 2F8h and IRQ3 (default
entry).
Disable The infrared interface is disabled.
LPT Port
This field is used to specify the address and the interrupt used by the parallel port.
LPT1 The parallel port uses the address 378h and IRQ7 (default).
LPT2 The parallel port uses the address 278h and IRQ5.
Disable The parallel port is disabled.
A26391-K64-Z100-2-7619 53