Specifications

Troubleshooting
The mouse does not respond
If the mouse does not work, it can have the following causes:
Incorrect settings in System Setup
Check the Pointing Device setting in System Setup.
If a PS/2 mouse is connected to the notebook, the field should be set to PS/2
Type.
If a serial mouse is connected, it should be set to Serial Type.
Check the correct Com Port setting in System Setup. The serial interface must be
enabled.
Check the correct Serial Interface setting in Security Setup. The serial interface
must be enabled.
No mouse driver installed
Ensure that the correct mouse driver has installed correctly before starting the
application. For information on the mouse driver, consult the manuals supplied
with the mouse or your application.
The mouse is not properly connected
Switch off the notebook.
Check to ensure that the mouse cable is connected to the notebook properly.
If you are using an adapter or extension cable, check the connections here, too.
Switch on the notebook.
The notebook will not write to floppy disk
Check whether that floppy disk is OK and is not write-protected.
Ensure that Diskette Write in Security Setup is not set to Enable.
92 A26391-K64-Z100-2-7619