User's Manual Part 1

Important Information

This equipment has been tested and found to comply with the

limits for a class B digital peripheral, pursuant to Part 15 of the

FCC Rules and meets all requirements of the Canadian

Interference-Causing Equipment Regulations. These limits are

designed to provide reasonable protection against harmful

interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment on and off, the user is

encouraged to try to correct the interference by one or more

of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult the dealer or an experienced radio/T.V. technician for

help

Change or modifications not expressly approved by

Siemens Aktiengesellschaft

could void authority to operate the equipment.

Important Information

FCC Compliance Statement

FCC ID: L82TOPSEC701

Information to the User

NOTE:

FCC Compliance Statement

If necessary, the user should contact the dealer or an

experienced radio/television technician for additional

suggestions. The user may find the following booklet,

prepared by the Federal Communications Commission

helpful:

"How to Identify and Resolve Radio-TV Interference Problems."

This booklet is available from the US. Government Printing

Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

Siemens AG

TopSec 701