User's Manual

79
Appendix
Gigaset SL 3501, USA, A31008-L350-B102-1-7619
anha.fm
06.02.03
Maintenance
Simply wipe the base station and handset with a damp cloth or an antistatic wipe.
Never
Never Never
Never use a dry cloth as this can cause static discharge.
Troubleshooting
If your telephone does not behave the way you want it to, first try to solve the prob-
lem using the following list.
Fault Possible cause Solution
No display Handset not activated Hold down end call key a
for 1 second
battery empty Charge or replace the batte-
ry (page 5)
No reaction to keystroke Keypad protection activated Hold down the ª key for
1 second
No radio connection to the
base station – E.g. base sta-
tion 1 is flashing
Handset outside the base
station range
Move closer to the base sta-
tion
Handset not registered Register the handset
(page 54)
Base station not connected Check the connector at base
station (page 3)
Handset does not ring Ringer off Activate the ringer
Hold down the
« key
You cannot hear The key F was pressed –
the microphone is “muted”
Press
Î, to activate the
microphone
The incoming call number is
not displayed although Cal-
ler ID is set.
The telephone number
transmission is blocked or
not available
The callers must permit the
transmission of their tele-
phone numbers at their net-
work provider
The ringer/dialing tone
cannot be heard.
You have changed the tele-
phone cord on your Gigaset
Ensure, when purchasing a
new cord, that it has the cor-
rect pin assignment (3-4 as-
signment of the telephone
leads).
Error beep is generated (de-
scending tone sequence)
Wrong input Repeat the procedure; note
the display and, if necessary,
refer to the operating in-
structions
The answering machine an-
nounces “PIN is incorrect”
during remote operation
The system PIN entered is
incorrect or set to 0000
Re-enter the system PIN or
set a PIN other than 0000