User's Manual

"hearing" range. Room monitor is discussed in detail in Chapter 2 The Basics.
Mobile Settings
The options in Mobile Settings allow you to adjust the way information is presented: the volume, display contrast, what tones you
will hear, etc. You can also decide to answer calls by a simply removing the cordless handset from the charger cradle, reset your
handset to the factory defaults, or change the language. Most of these options are contained in the Local Settings menu which is
covered later in this chapter
To access Mobile Settings, press the MENU key ~ Highlight "Mobile Settings" using the ππand θθ soft keys and press the OK
key.
Some features can only be enabled or disabled. A checkmark next to a feature means that the feature is enabled or on. Press
MENU or ⇑ to back out of the menu without changing the setting.
Any changes to these settings are effective immediately and persist until you change them.
Handset Volume
The following procedure adjusts listening volume both when the cordless handset is being used like a receiver and when a headset
is plugged into the handset
1 Scroll to the Handset Volume and press OK
2 Press τ and υ to set the desired volume
Press OK to save the changes.
Ringer Settings
You can set the cordless handset's rings so that they tell you which line the incoming call is using. To adjust ringer volume and
pitch:
88 Chapter 7 . Customizing Your System
1 Highlight "Ringer Settings" and press OK
2. Highlight the desired line and press OK. Your choices are Line 1,Line 2, and the intercom line
3. Highlight either Ringer Volume or "Ringer Pitch" and press OK
4. Press the τ and υ keys to the desired setting and press OK
Local Settings
See the Local Settings section later in this chapter.
Base Settings
Many of the cordless handset's interactions with the desk station or Base are governed by the Base Settings menu You access this
menu by pressing the MENU
key highlighting Base Settings" by using the  and  keys and pressing OK