User's Guide

hwc_startup.fm
Configuring the HiPath Wireless Controller
Working with the basic installation wizard
9034530-02,
March 2010
HiPath Wireless Controller, Access Points and Convergence Software V7.11, User Guide 47
•User – Enter the name of the user account.
• Security Level – Select the security level for this user account. Choices
are: authPriv, authNoPriv, noAuthnoPriv.
• Auth Protocol – If you have selected a security level of authPriv or
authNoPriv, select the authentication protocol. Choices are: MD5, SHA,
None.
• Auth Password – If you have selected a security level of authPriv or
authNoPriv, enter an authentication password.
• Privacy Protocol – If you have selected the security level of authPriv,
select the privacy protocol. Choices are: DES, None
• Privacy Password – If you have selected the security level of authPriv,
enter a privacy password.
•Engine ID – If desired, enter an engine ID. The ID can be between 5 and
32 bytes long, with no spaces, control characters, or tabs.
• Trap Destination – If desired, enter the IP address of a trap destination.
10. In the OSPF section, select the Enable checkbox to enable OSPF, if
applicable. Use OSPF to allow the HiPath Wireless Controller to participate
in dynamic route selection. OSPF is a protocol designed for medium and
large IP networks with the ability to segment routes into different areas by
routing information summarization and propagation.
Do the following:
•Port – Click the physical interface of the HiPath Wireless Controller you
want to assign as a router port.
•Area ID – Type the desired area. Area 0.0.0.0 is the main area in OSPF.