User's Guide

Configuring a VNS
hwc_vnsconfiguration.fm
Configuring a Topology
9034530-02, March 2010
306 HiPath Wireless Controller, Access Points and Convergence Software V7.11, User Guide
3. For each filtering rule you are defining, do the following:
• In the IP/subnet:port box, type the destination IP address. You can also
specify an IP range, a port designation, or a port range on that IP address.
• In the Protocol drop-down list, click the applicable protocol. The default
is N/A.
• Click OK to add the user-defined rule to the rule table.
4. To add a predefined filter, click the Add Predefined button, then select the
desired filter from the drop-down list. Click Add to add the rule to the rule
table.
5. By default, user-defined rules are enabled on ingress (In) and egress (Out),
and are assumed to be Allow rules. To disable the rule in either direction, or
to make it a Deny rule, click the new filter, then de-select the relevant
checkbox.
6. To edit the order of filters, click the filter, and then click the Up and Down
buttons. The filtering rules are executed in the order you define here.
7. To delete a user-defined rule, click the filter, then click the Delete button.
8. To save your changes, click Save.
Note: For external Captive Portal, you need to add an external server to a
non-authentication filter.