User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Configuring Wireless AP settings
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 89
3. To select the Wireless APs for status change, do one of the following:
• For a specific Wireless AP, select the corresponding checkbox.
• For Wireless APs by category, click one of the Select Wireless APs
options.
Note: You must consider all the three AP variants — HiPath Wireless AP,
HiPath Wireless Outdoor AP, and HiPath Wireless 802.11n AP — as Local.
To clear your Wireless AP selections, click Clear All.
4. Click the appropriate Perform action on selected Wireless APs option:
• Approved – Change a Wireless AP's status from Pending to Approved,
if the AP Registration page was set to register only approved Wireless
APs.