User's Manual

Configuring the Wireless AP
hwc_apstartup.fm
Configuring the Wireless APs for the first time
A31003-W1050-U100-2-7619
, March 2008
82 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
LED L2
The LED L2 indicates the status of the Ethernet port:
Note: A 10 Mb Ethernet connection is considered a warning state since it is not
sufficient to sustain a single radio in the legacy 11g or 11a modes.
4.3 Configuring the Wireless APs for the first time
Before the Wireless AP is configured for the first time, you must first confirm that
the following has already occurred:
• The HiPath Wireless Controller has been set up. For more information, see
Chapter 3, “Configuring the HiPath Wireless Controller”.
• The Controller, Access Points and Convergence Software has been
configured. For more information, see Chapter 3, “Configuring the HiPath
Wireless Controller”.
• The Wireless APs have been installed.
L3/L4 Radio status
Off Radio off
Solid Blue Radio in HT mode
Solid Green Radio in legacy mode
Table 12 LEDs L3 and L4, and corresponding radio state
L2 Ethernet port’s status
Off No Ethernet connection
Solid Blue 1 Gb Ethernet connection
Solid Green 100 Mb connection
Solid Orange 10 Mb connection
Table 13 LED L2 and Ethernet port’s status