User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Discovery and registration overview
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 81
LEDs L3 and L4
The LEDs L3 and L4 indicate the detailed state of the Wireless AP. The LED1,
and LEDs L3 and L4 work in conjunction to indicate the general and detailed state
of the 802.11n AP.
Table 11 provides a composite view of the three LEDs and the corresponding
state of the 802.11n AP:
After initialization and discovery is completed and the 802.11n AP is connected
to the HiPath Wireless Controller, the LEDs L3 and L4 indicate the state of the
corresponding radio — L3 for Radio 5 GHz, and L4 for Radio 2.4 GHz.
Figure 9 provides a view of the LEDs L3 and L4 and the corresponding radio state
after the discovery is completed.
L1 HiPath Wireless 802.11n AP’s general state
Blink Green Initialization and discovery in progress
Blink Red Error during initialization and discovery
Solid Green Discovery finished; AP connected to the HiPath Wireless Controller
Table 10 LED L1 and Wireless AP’s status
L3 L4 L1 HiPath Wireless 802.11n AP’s detailed state
Off Off Blink Green Initialization: Power-on self test (POST)
Blink Green Blink Green Initialization: Random delay
Solid Green Blink Green Initialization: Vulnerable period / WDS scanning
Blink Red Reset to factory defaults
Blink Green Off Blink Green Network discovery: 802.1x authentication
Blink Red Failed 802.1x authentication
Blink Green Blink Green Network discovery: DHCP
Blink Red Default IP address
Solid Green Blink Green Network discovery: HWC discovery / connect
Blink Red Discovery failed
Solid Green Off Blink Green Connecting to HWC: Registration
Blink Red Registration failed
Blink Green Blink Green Connecting to HWC: Image upgrade
Blink Red Image upgrade failed
Solid Green Blink Green Connecting to HWX: Configuration
Blink Red Configuration failed
Blink Green Solid Green AO operating normally: Forced image upgrade
Blink Red Image upgrade failed
Table 11 LEDs L3, L4 and L1, and Wireless 802.11n AP’s detailed state