User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Discovery and registration overview
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 79
The following table provides a composite view of the three LED lights of the
HiPath Wireless Outdoor AP’s state:
Note: After discovery is finished, Left and Right LEDs will be Green for Ethernet
uplink, and Yellow for WDS uplink.
Note: If the fatal AP error occurs, the Status LED will be solid Red.
R1 LED R2 LED F LED HiPath Wireless Outdoor AP’s
detailed status
Off
Off Blinking Red Initialization: Power-on-self test (POST)
Blinking
Green
Blinking Red Initialization: Random delay
Solid Green
Blinking Red Initialization: Vulnerable Period
Solid Red Reset to factory defaults
Solid Green Blink Red WDS scanning
Blinking
Green/
Yellow
Off
Blinking Red Network discovery: 802.1x
authentication
Solid Red Failed 802.1x authentication
Blinking
Green/Yellow
Blinking Red Network discovery: DHCP
Solid Red Default IP address
Solid Green/
Yellow
Blinking Red Network discovery: HWC discovery/
connect
Solid Red Discovery failed
Solid
Green Off
Blinking Red Connecting with HWC: Registration
Solid Red Registration failed
Blinking
Green/Yellow
Blinking Red Connecting with HWC: Image upgrade
Solid Red Image upgrade failed
Solid Green/
Yellow
Blinking Red Connecting with HWC: Configuration
Solid Red Configuration failed
Blinking
Green/Yellow
Off AP operating and running normally:
Forced image upgrade
Solid Red Image upgrade failed
Table 9 HiPath Wireless Outdoor AP LED status