User's Manual

Configuring the Wireless AP
hwc_apstartup.fm
Discovery and registration overview
A31003-W1050-U100-2-7619
, March 2008
78 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
Note: The Left and Right LEDs turn on after the center LED. This allows you to
distinguish easily between the Center LED and the Left/Right LEDs.
Note: If the Center LED begins blinking RED, it indicates that the Wireless AP’s
state has failed.
Note: Random delays do not occur during normal reboot. A random delay only
occurs after vulnerable period power-down.
The Wireless AP can be reset to its factory default settings. For more information,
see Section 11.2, “Resetting the Wireless APs to their factory default settings”, on
page 313.
4.2.3.2 HiPath Wireless Outdoor AP LED status
The following figure depicts the location of the LEDs on the HiPath Wireless
Outdoor AP.
Figure 8 HiPath Wireless Outdoor AP LEDs
Note: Although the HiPath Wireless Outdoor AP has six LEDS, only R1, R2 and
F LEDs are used in the current release. The remaining LEDs are disabled.
The Center, Left, and the Right LEDs work in conjunction to indicate the general,
high-level and detailed state respectively.