User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Discovery and registration overview
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 75
Figure 7 HiPath Wireless AP LEDs
Warning: Never disconnect a Wireless AP from its power supply during a
firmware upgrade.
Disconnecting a Wireless AP from its power supply during a firmware upgrade
may cause firmware corruption rendering the AP unusable.
LEDs color codes
The AP LEDs indicate “normal-operation”, “warning/special”, or “failed” state of
the Wireless AP in the following color codes:
• Green – Indicates the normal-operation state.
• Orange/Amber – Indicates the warning, or special state such as WDS.
• Red – Indicates the error state.
• Blinking – Indicates that the state, such as initialization, or discovery is in
progress.
• Steady – Indicates that the state is stable/completed. For example,
initialization finished, or discovery completed.
Center LED
The Center LED indicates the general status of the Wireless AP:
Center LED HiPath Wireless AP’s status
Blinking Green Initialization and discovery in progress via Ethernet link
Blinking Orange/Amber Initialization and discovery in progress via WDS link
Blinking Red Error during initialization/discovery process
Table 5 Center LED and Wireless AP’s status
Left LED
2.4 GHz
radio activity
Right LED
5 GHz radio
activity
Status
LED