User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Wireless AP overview
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 69
Note: After you run these commands, you must reboot the Wireless AP for the
configuration to take effect.
CLI commands to configure static IP address in the HiPath Wireless 802.11n
AP:
Syntax
cset <dhcp disable>
cset <ipaddr>
cset <ipmask>
cset <gateway>
capply
csave
Parameters
Note: After you run these commands, you must reboot the Wireless 802.11n AP
for the configuration to take effect.
Parameter Name Description
dhcp disable By default, the Wireless AP is configured to acquire its IP
address via the DHCP assignment. The command disables
the DHCP server.
ipaddr Specifies the IP address.
ipmask Specifies the subnet.
gateway Specifies the IP address of the network gateway.
capply Applies the configuration.
csave Saves the configuration.
Table 4 CLI command to configure static IP address in the HiPath Wireless
802.11n AP