User's Manual

Configuring the Wireless AP
hwc_apstartup.fm
Wireless AP overview
A31003-W1050-U100-2-7619
, March 2008
68 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
Note: If the telnet session is not established within 30 seconds of successful
pinging, the Wireless AP again initiates the process of getting the IP address
via the DHCP assignment.
Note: The default user name and the password for telnet access are:
• User Name – admin
• Password – new2day
You can override the default password by setting up a new telnet access
password on the Wireless Registration screen. For more information see,
Section 4.1.6.1, “Enabling/Disabling telnet access and setting up new Telnet
Access Password via the controller’s user interface”, on page 70.
4. Configure the static configuration, using the following CLI commands.
CLI commands for configuring static IP address in the HiPath Wireless AP:
Note: The CLI commands to configure the static IP address in the HiPath
Wireless AP and the HiPath Wireless Outdoor APs are identical.
Syntax
set <dhcp disable>
set <ipaddr>
set <ipmask>
Parameters
Parameter Name Description
dhcp disable By default, the Wireless AP is configured to
acquire its IP address via the DHCP
assignment. The command disables the
DHCP server.
ipaddr Specifies the static IP address.
ipmask Specifies the subnet
Table 3 CLI command to configure static IP address in the HiPath Wireless
AP