User's Manual

Configuring the HiPath Wireless Controller
hwc_startup.fm
Completing the system configuration
A31003-W1050-U100-2-7619
, March 2008
56 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
6. Click Add. The new filter is displayed on the Filter section of the page.
7. Click the new filter.
8. To allow traffic, select the Allow checkbox.
9. To adjust the order of the filtering rules, click Up or Down to position the rule.
The filtering rules are executed in the order defined here.
10. To save your changes, click Save.
3.3 Completing the system configuration
Once you have performed the initial configuration of the HiPath Wireless
Controller, you are now ready to do the following:
• Configuring the VNS – For more information, see Chapter 5, “Virtual
Network Services”.
• Registering and assigning APs to the VNS – For more information, see
Chapter 4, “Configuring the Wireless AP”.
3.4 Ongoing Operations of the Controller, Access Points and Convergence
Software
Once you have configured the VNS and registered and assigned APs to the VNS,
the Controller, Access Points and Convergence Software system configuration is
complete. Ongoing operations of the Controller, Access Points and Convergence
Software system can include the following:
• HiPath Wireless Controller System Maintenance
• Wireless AP Maintenance
• Client Disassociate
• Logs and Traces
• Reports and Displays
For more information, see Chapter 11, “Performing system maintenance”.