User's Manual

Configuring the HiPath Wireless Controller
hwc_startup.fm
Performing the first time setup of the HiPath Wireless Controller
A31003-W1050-U100-2-7619
, March 2008
54 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
3. On the IP Addresses page, click the appropriate interface.
4. Select the corresponding Management checkbox.
5. To save your changes, click Save.
3.2.9 User defined port-based exception filters
You can add specific filtering rules at the port level in addition to the built-in rules.
Such rules give you the capability of restricting access to a port, for specific
reasons, such as a Denial of Service (DoS) attack.
The filtering rules are set up in the same manner as filtering rules defined for a
VNS — specify an IP address and then either allow or deny traffic to that address.
For more information, see Section 6.9, “Configuring filtering rules for a VNS”, on
page 194.