User's Manual

Configuring the HiPath Wireless Controller
hwc_startup.fm
Performing the first time setup of the HiPath Wireless Controller
A31003-W1050-U100-2-7619
, March 2008
48 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
6. Click Add. The new route is added to the list of routes.
7. Select the Override dynamic routes checkbox to give priority over the OSPF
learned routes, including the default route, which the HiPath Wireless
Controller uses for routing. This option is enabled by default.
To remove this priority for static routes, so that routing is controlled
dynamically at all times, clear the Override dynamic routes checkbox.
Note: If you enable dynamic routing (OSPF), the dynamic routes will normally
have priority for outgoing routing. For internal routing on the HiPath Wireless
Controller, the static routes normally have priority.
8. To save your changes, click Save.
To view the forwarding table on the HiPath Wireless Controller:
1. From the main menu, click Reports & Displays. The HiPath Reports &
Displays page is displayed.
2. To view the static routes that have been defined for the HiPath Wireless
Controller, click Forwarding Table. The Forwarding Table is displayed.
This report displays all defined routes, whether static or OSPF, and their
current status.
3. To update the display, click Refresh.