User's Manual

hwc_startup.fm
Configuring the HiPath Wireless Controller
Performing the first time setup of the HiPath Wireless Controller
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 45
The lower portion of the HiPath Wireless Controller Configuration page
displays the number of Ethernet ports of the HiPath Wireless Controller:
• HiPath Wireless Controller C2400 – Four Ethernet ports
• HiPath Wireless Controller C20 – Two Ethernet ports
Note: All images of the HiPath Wireless Assistant in this User Guide
represent the HiPath Wireless Controller C2400.
3. Click a port.
Port configuration allows for the explicit state of the administration state for
each interface. By default, data interface states will be enabled. If they are not
enabled, you can enable them each of them individually. A disabled interface
does not allow data to flow (receive/transmit).
4. Type the following:
• IP address – The IP Address of the physical Ethernet port.
• Subnet mask – The appropriate subnet mask for the IP address, which
separates the network portion from the host portion of the address
(typically 255.255.255.0).