User's Manual

hwc_startup.fm
Configuring the HiPath Wireless Controller
Performing the first time setup of the HiPath Wireless Controller
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 39
Note: All images of the HiPath Wireless Assistant in this User Guide represent
the HiPath Wireless Controller C2400. In the footer of the HiPath Wireless
Assistant, the following is displayed:
• [host name | product name | up time]
For example, [HWC-206 | C2400 | 01 days, 06:29]. If your HiPath Wireless
Assistant is running the C2400 license, the footer will display C2400.
• If there is no key (unlicensed), the product name will not be displayed.
• User is the user id you used to login in. For example, admin.
• Port Status is the connectivity state of the port. M represents the Management
interface, which is on eth0 and the numbered lights reflect the esa ports on the
system. Green indicates the interface is up and running. Red indicates the
interface is down. The F icon represents the flash drive status: green if the flash
drive is mounted, and red if the flash drive is not mounted.
7. From the main menu, click Wireless Controller Configuration. The HiPath
Wireless Controller Configuration page is displayed.
8. In the left pane, click IP Addresses. The factory default settings for the
HiPath Wireless Controller are displayed.
9. In the Management Port Settings section, click Modify. The System Port
Configuration page is displayed.