User's Manual

Virtual Network configuration
hwc_vnsconfiguration.fm
Configuring filtering rules for a VNS
A31003-W1050-U100-2-7619
, March 2008
202 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
To define filtering rules for a filter ID group:
1. From the main menu, click Virtual Network Configuration. The Virtual
Network Configuration page is displayed.
2. In the left pane Virtual Networks list, click the VNS you want to define filtering
rules for a filter ID group. The Topology tab is displayed.
3. Click the Filtering tab.
4. From the Filter ID drop-down list, click one of the names you defined in the
Filter ID Values field on the RAD Policy tab. For example, select one of your
organization’s user groups, such as Sales, Engineering, Teacher, Guest, etc.
The Filtering tab automatically provides a Deny All rule already in place. This
rule can be modified to Allow All, if appropriate to the network access needs
for this VNS.
5. For each filtering rule you are defining, do the following:
• In the IP/subnet:port box, type the destination IP address. You can also
specify an IP range, a port designation, or a port range on that IP address.
• In the Protocol drop-down list, click the applicable protocol. The default
is N/A.
6. Click Add. The information is displayed in the Filter Rules section of the tab.
7. Click the new filter, then do the following: