User's Manual

hwc_vnsconfiguration.fm
Virtual Network configuration
Configuring filtering rules for a VNS
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 199
The Filtering tab automatically provides a Deny All rule already in place. Use
this rule as the final rule in the non-authenticated filter for Captive Portal.
5. For each filtering rule you are defining, do the following:
• In the IP/subnet:port box, type the destination IP address. You can also
specify an IP range, a port designation, or a port range on that IP address.
• In the Protocol drop-down list, click the applicable protocol. The default
is N/A.
6. For Captive Portal assignment, define a rule to allow access to the default
gateway for this VNS:
• Select IP/Port.
• Type the default gateway IP address that you defined in the Topology tab
for this VNS.
7. Click Add. The information is displayed in the Filter Rules section of the tab.
8. Click the new filter, then do the following:
• If applicable, select In to refer to traffic from the wireless device that is
trying to get on the network.
• If applicable, select Out to refer to traffic from the network host that is
trying to get to a wireless device.