User's Manual

Virtual Network configuration
hwc_vnsconfiguration.fm
Assigning Wireless AP radios to a VNS
A31003-W1050-U100-2-7619
, March 2008
174 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
4. Configure the topology for your VNS accordingly. For more information, see
Section 6.3, “Topology for a VNS”, on page 164.
5. To save your changes, click Save.
6.3.3 Saving your topology properties
Once your topology is defined, you can then save your topology properties to
continue configuring your VNS. To save your topology properties, click Save.
6.4 Assigning Wireless AP radios to a VNS
If two HiPath Wireless Controllers have been paired for availability (for more
information, see Section 7.1, “Availability overview”, on page 251), each HiPath
Wireless Controller's registered Wireless APs will appear as foreign in the list of
available Wireless APs on the other HiPath Wireless Controller.
Once you have assigned a Wireless AP radio to eight VNSs, it will not appear in
the list for another VNS setup. Each radio can support up to eight SSIDs (16 per
AP). Each AP can be assigned to any of the VNSs defined within the system. The
HiPath Wireless Controller can support the following:
• C2400 – Up to 64 VNSs