User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Configuring Wireless AP settings
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 135
•Video VI – For each radio, click the number of retries for the Video
transmission queue. The default value is adaptive (multi-rate). The
recommended setting is adaptive (multi-rate).
•Voice VO – For each radio, click the number of retries for the Voice
transmission queue. The default value is adaptive (multi-rate). The
recommended setting is adaptive (multi-rate).
• Turbo Voice TVO – For each radio, click the number of retries for the
Turbo Voice transmission queue. The default value is adaptive (multi-
rate). The recommended setting is adaptive (multi-rate).
10. To configure default Wireless AP settings for only the Wireless 802.11n AP
3610/3620, click the 11n AP Defaults tab.
11. In the AP Properties section, do the following:
• Poll Timeout – Type the timeout value, in seconds. The Wireless AP
uses this value to trigger re-establishing the link with the HiPath Wireless
Controller if it (Wireless AP) does not get an answer to its polling. The
default value is 10 seconds.
• Poll Interval – Type the interval value, in seconds, for polling the
controller. The default value is 2 seconds.
• Telnet Access – Click whether Telnet Access to the Wireless AP is
enabled or disabled.