User's Manual

hwc_apstartup.fm
Configuring the Wireless AP
Configuring Wireless AP settings
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 103
10. In the Base Settings section, do the following:
• Radio Mode – Click one of the following radio options:
•a – Click to enable only the 802.11a mode of the 802.11a/n radio. If
disabled, the Wireless 802.11n AP will not accept associations from
11a clients.
•a/n – Click to enable both the 802.11a mode and the 802.11n mode
of the 802.11ba/n radio.
•off – Click to disable the 802.11a/n radio.
Note: Depending on the radio options you select, some of the radio
settings may not be available for configuration.
• Channel Width – Click the channel width for the radio:
•20MHz – Click to allow 802.11n clients to use the primary channel
(20MHz) and non-802.11n clients, beacons, and multicasts to use the
802.11a radio protocols.