User's Manual

Performing system maintenance
hwc_ongoing.fm
Working with system logs, trace messages, and audits
A31003-W1050-U100-2-7619
, March 2008
348 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
To view Wireless AP traces:
1. From the main menu, click Logs & Traces. The Logs & Traces page is
displayed.
2. Click the AP: Traces tab. The Wireless AP trace page is displayed.
Caution: In order for the Debug Info option on the Wireless AP Traces page
to return trace messages, this option must enabled while Wireless AP debug
commands are running. To do so, you need to run a Wireless AP CLI
command to turn on a specific Wireless AP debug. Once the CLI command
is run, select the Debug Info option, and then click Retrieve Traces. For
more information, see the HiPath Wireless Controller, Access Points and
Convergence Software CLI Reference Guide.
Because Wireless AP debugging can affect the normal operation of Wireless
AP service, enabling debugging is not recommended unless specific
instructions are provided.
3. In the Active Wireless AP list, click the Wireless 802.11n AP whose trace
messages you want to view.
4. In the Collect traces for section, do the following:
• Configurations – Select to collect trace configuration information.