User's Manual

Performing system maintenance
hwc_ongoing.fm
Resetting the Wireless APs to their factory default settings
A31003-W1050-U100-2-7619
, March 2008
316 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
Figure 21 Position of the reset button with the housing cover removed
Attention: The reset button is located below the housing cover beside the
sockets for the external antennas. To access the reset button, you must remove
the housing cover. For more information, see the HiPath Wireless Outdoor AP
Installation Guide.
11.2.1.2 Resetting the HiPath Wireless 802.11n AP to its factory
default settings
You can set the HiPath Wireless 802.11n AP to its factory default settings by
pressing and holding the reset button for approximately four seconds.