User's Manual

hwc_ongoing.fm
Performing system maintenance
Resetting the Wireless APs to their factory default settings
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 315
Reset button (Hardware)
Some models of the HiPath Wireless AP have a reset button. If your model is
equipped with a reset button, you can set it to its factory default settings by
pressing and holding the reset button for approximately six seconds.
Note: If you press the reset button and do not hold it over six seconds, the HiPath
Wireless AP will merely reboot, and not reset to its factory defaults.
The following figure illustrates the location of the reset button on the HiPath
Wireless APs.
Figure 20 Position of the reset button in the HiPath Wireless AP
11.2.1.1 Resetting the HiPath Wireless Outdoor AP to its
factory default settings
All models of the HiPath Wireless Outdoor AP have a reset button.
You can set the HiPath Wireless Outdoor AP to its factory default settings by
pressing and holding the reset button for approximately six seconds.
Note: If you press the reset button and do not hold it over six seconds, the HiPath
Wireless Outdoor AP will merely reboot, and not reset to its factory defaults.
The following figure illustrates the location of the reset button on the HiPath
Wireless Outdoor AP.
AC/DC Power Supply
Ethernet Port
Reset Button