User's Manual

hwc_reports.fm
Working with reports and displays
Viewing reports
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 305
•Rb – 802.11b protocol enabled. Possible values are on or off.
•Rg – 802.11g protocol enabled. Possible values are on or off.
•DP – DTIM period
•BP – Beacon Period
•SRL – Short Retry Limit
•LRL – Long Retry Limit
•RT – RTS Threshold
•FT – Fragmentation Threshold
•Ch – Channel served by the corresponding radio.
•PL – Power Level (Defined in the Wireless AP radio properties pages.)
•BR – Basic Rate (Only applies to Wireless APs running 3.1 or earlier.)
•ORS – Operational Rate Set (Only applies to Wireless APs running 3.1 or
earlier.)
•MnBR – Minimum Basic Rate (For more information, see the Wireless AP
radio configuration tabs.)
•MxBR – Maximum Basic Rate
•MxOR – Maximum Operational Rate
•RxDV – Receive Diversity
•TxDV – Tx Diversity
•Pmb – Preamble (long, short)
•PM – Protection Mode
•PR – Protection Rate
•PT – Protection Type
•BSS – Basic Service Set
•MAC – MAC address
•BSS: MAC – Also called BSSID, this is the MAC address of a (virtual)
wireless interface on which the Wireless AP serves a BSS/VNS. There could
be 8 per radio.
•Port – Ethernet Port and associated IP address of the interface on the HiPath
Wireless Controller through which the Wireless AP communicates.
•HW – Hardware version of the Wireless AP.
•SW – Software version executing on theWireless AP.