User's Manual

hwc_controlleravailmobility.fm
Availability, mobility, and controller functionality
Configuring Check Point event logging
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 269
3. To enable check point logging, select the Enable Check Point Logging
checkbox.
4. Type the following information:
• Check Point Server IP – Specifies the IP address of the ELA
Management Station
•ELA Port – Specifies the port to use for ELA. The default port is 18187.
• ELA Log Interval – Specifies the amount of time (in milliseconds) you
want the system to wait before attempting to log once there is a
connection between HiPath Wireless Controller and the Check Point
gateway. The default is 100 milliseconds.
• ELA Retry Interval – Specifies the amount of time (in milliseconds) you
want the system to wait before attempting a re-connection between
HiPath Wireless Controller and the Check Point gateway. The default is
2000 milliseconds.
• ELA Message Queue Size – Specifies the number of messages the log
queue holds if the HiPath Wireless Controller and the Check Point
gateway become disconnected. The default is 1000 log entries.
•SIC Name – Specifies the Secure Internal Communication (SIC) Name,
your security-based ID.